Saddle clamp 10016 series

Clamp Saddle With Stainless Steel (AISI304) Bolt Stainless Steel Reinforcing Ring (AISI430) Pressure Values Ø 25 mm – Ø 110 mm : PN 16 2” – 2 ½” : PN 10 Ø 125 mm – Ø 225 mm : PN 10 3” – 4” : PN 6 Installation Areas Urban Potable Water Networks – Landscaping Systems Agricultural Irrigation – Greenhouses -Clamp saddles should be kept away from hard and sharp objects during the storage and installation. If the installation is laid under the ground, it should be covered with sand to protect it from hard and sharp objects. Any damaged adaptor should not be used absolutely. -The o-ring should be placed in its socket properly in order not to be unsettled during the installation. -Male adaptors to be used with Clamp Saddles, should be wrapped up with the teflon band with the tightening direction and should be wrapped enough to prevent leakage. -Drilling the pipe after the installation of Clamp Saddles can cause the damage of the threads. Thus, drilling must be carried out in a way that it does not touch the threads with a suitable drill bit. -If the dimension of the installed pipes is bigger than the standard values upper and lower parts will not contact each other. Under these circumstances, there is no need to tighten the bolts till the upper and lower body parts contact or hammer the slides to the end point. -Bolts and nuts must be tightened mutually balanced during installation of the Clamp Saddles.